#CISCO ASA ASDM UNREACHABLE IN TUNNEL SOFTWARE#
! L2TP demand-dial using IPsec transport-mode, while Cisco VPN software (and hardware clients) uses IPsec tunnel-mode, hence the dynamic map (which is used for all demand-dial VPN clients) must include both.Ĭrypto dynamic-map DYN_MAP 10 set transform-set L2TP-IPSEC IPSEC-AES ESP-3DES-SHA ESP-3DES-MD5 ESP-DES-SHA ESP-DES-MD5Ĭrypto dynamic-map DYN_MAP 10 set security-association lifetime seconds 86400 ! crypto dynamic-map for demand-dial vpn connections: L2TP, Cisco ! 3DES is the common cypher supported by both XP and Vista.Ĭrypto ipsec transform-set ESP-AES-256-MD5 esp-aes-256 esp-md5-hmacĬrypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmacĬrypto ipsec transform-set ESP-DES-MD5 esp-des esp-md5-hmacĬrypto ipsec transform-set ESP-AES-192-MD5 esp-aes-192 esp-md5-hmacĬrypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmacĬrypto ipsec transform-set ESP-AES-256-SHA esp-aes-256 esp-sha-hmacĬrypto ipsec transform-set ESP-AES-128-SHA esp-aes esp-sha-hmacĬrypto ipsec transform-set ESP-AES-192-SHA esp-aes-192 esp-sha-hmacĬrypto ipsec transform-set ESP-AES-128-MD5 esp-aes esp-md5-hmacĬrypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmacĬrypto ipsec transform-set L2TP-IPSEC esp-3des esp-md5-hmacĬrypto ipsec transform-set L2TP-IPSEC mode transportĬrypto ipsec transform-set IPSEC-AES esp-aes-256 esp-sha-hmac ! Transforms for supporting both demand-dial and persistent (transport-mode & tunnel-mode) IPsec VPNs Snmp-server enable traps snmp authentication linkup linkdown coldstart ! enable server, enable server management on both the inside and management networks ! Don’t make VPN traffic subject to ACL filtering Timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00ĭynamic-access-policy-record DfltAccessPolicy Static (inside,outside) tcp interface ! Allow L2TP establishment to the outside interface of the PIXĪccess-group INBOUND in interface outside ! Create a hole in the firewall mapping a specific port from the outside interface to a computer on the inside network ! Do port-address-translation (PAT) for all traffic with source IP of 192.168.0.0/24 with destination off-link ! Allow the inside interface to respond to all icmp requests
Icmp unreachable rate-limit 1 burst-size 1 ! Pool of IP addresses for demand-dial VPN Clients ! Allows a TCP or UDP connection to port 80 on the outside interfaceĪccess-list INBOUND extended permit object-group TCPUDP any host eq www An access-group later in this config references this ACL for allowing inbound L2TP session connections.Īccess-list INBOUND extended permit udp any eq 1701 ! L2TP uses UDP port 1701 to establish a connection. Security-level is set to a number higher than the outside interface ! Security-level is higher the closer you get to the network that is being protected
Security-level must be set to a number lower than the inside Interface
#CISCO ASA ASDM UNREACHABLE IN TUNNEL PASSWORD#
Session Type: IKE, Duration: 0h:00m:32s, Bytes xmt: 0, Bytes rcv: 0, Reason: Phase 2 Errorģ 10:06:17 713902 Group =, IP =, Removing peer from correlator table failed, no match!ġ 10:06:17 713900 Group =, IP =, construct_ipsec_delete(): No SPI to identify Phase 2 SA!ģ 10:06:17 713902 Group =, IP =, QM FSM error (P2 struct &0xd5b62858, mess id 0x9ddc5616)!Įnable password LTFd9GMmqnbHlQ9Q encrypted Nov 8 15:11:00 racoon: : INFO: respond new phase 2 negotiation: .Ĥ 10:06:17 113019 Group =, Username =, IP =, Session disconnected.
Nov 8 15:11:00 racoon: WARNING: ignore INITIAL-CONTACT notification, because it is only accepted after phase1. Nov 8 15:11:00 racoon: ERROR: failed to get sainfo. Nov 8 15:11:00 racoon: ERROR: failed to pre-process packet.
It seems that phase 1 works, but phase 2 fails. I am trying to get a site to site VPN going between a pfSense firewall and a Cisco ASA.